Kit contains:

1. Transmission Skid plate (the missing link)

2. Fuel Tank skid plate and mounting hardware.



Options available are:


1. Superleggera Series American Made high strength Aluminum Skids, an upgrade from the flimsy stamped steel units that came from the factory, the transsmision lacks any coverage and the fuel tank is only covered in the middle with an easily bent pan. This armor is suited for the average off-roader, it will protect against rocks, sand, mud, logs and debris, it's not suited for rock crawlers but suits most users. (in production and start shipping mid august)


2. ADHD Cold Rolled Black Zinc Powder Coated Steel. Not Stainless, but not far from it. These heady duty skids are in the HD line of our products. Designed for hardcore off-roaders, expedition rigs and overland vehicles with increased weight, thus needing a higher tensile strenth sheet of steel under their belly. The finished units are black in color, an anti-corrosion protection that allows these skids to bolt on immediately. (in production & start shipping late september)


3. ADHD Stainless Steel Skids The toughest of the bunch. These used to be the only skids we made but they were too expensive and a bit overkill for a lot of people. These skids will absolutely take a beating and keep shining on. (currently sold out)




This kit of essential armor pieces didn't exist until 2020, neither did the essential worker. Many of us logged thousands of miles in 2020 while our friends and family worked from home (if they were lucky to keep working). This kit was intended to provide essential armor while keeping the cost low and the vehicle light and fuel efficient for the daily drive.

Your Montero came from the factory with a front skid to protect the sway bar, and an engine oil pan skid plate, which also protects the front differential, it also came with a narrow fuel tank skid plate that leaves the edges of the tank exposed, it even got a transfer case skid plate. The factory skid plates are all made of basic stamped sheet metal, but they're better than nothing! Which is nearly what the Gen 3 came with, only getting a front skid... yet this leaves a giant weakness exposed -  the transmission pan!! The pan of the transmission is made of fairly thin material when you consider putting the weight of a whole truck on it. Our skid plate bridges that gap with 'the missing link' transmission skid plate. 


The ADD fuel tank skid can be used to layer over the existing steel skid adding extra coverage, a better look and more rigidity to the set-up. The transmission protection fits underneath the Transmission Pan. It bolts to the cross members in four existing locations and additional fastening points are provided (and suggested!) for further rigidity.

These skid plates are more resilient than stock because stock had grossly inadequate protection in these areas, it's a great way to protect your investment, your drive train, and your fuel range for years to come. A dented tank holds less fuel and the Aisin transmission will really appreciate being stress free, the pan on these is not very thick and a good rock or branch could result in a trans leak for you. We've seen these transmissions put out 400,000+ miles if cared for, so we've done our best to provide protection without trapping additional heat, you'll note there's vents in the trans skid plate you dont see in the other plates, because heat is hard on a transmission, and this big pan could otherwise hold debri after being submerged in mud etc, these holes also allow it to drain.

The front of the skid bolts to where the mid-skid overlaps, the rear bolts to the passenger side of the cross-member, you'll want to drill 2 new holes in your cross member to fully secure this skid, but it will bolt on as-is. What you don't do is up to you. You may experience rattles or buzzes if you dont properly secure your skid plate, either do it right, or crank up the radio!


Want to learn more about installing? Check out this fun video made by Auto Offtopic Podcast hosts:




Write a review

Please login or register to review

ADHD - Adventure Driven Hardcore Design | Gen 2 Essential Worker's Skid Kit | Including "The Missing Link" Transmission & Catalytic Converter protection.

  • $385.00
  • $275.00

  • Ex Tax: $275.00

Available Options


Related Products

ADHD - Adventure Driven Hardcore Design - Gen 1 4 Door Montero Fuel Tank Skid Plate Armor

ADHD - Adventure Driven Hardcore Design - Gen 1 4 Door Montero Fuel Tank Skid Plate Armor

Currently in production, units will start shipping september 2021Designed for the toughest environme..

$222.00 $255.00 Ex Tax: $222.00

Tags: skidplate, gen 2, gen 2.5, Armor, Gen 2 Skid, sale